The 5-Year Sensitivity Test and Detector Cleaning
What the 5-year sensitivity test and cleaning cycle requires under NFPA 72 — how it interacts with the 10-year replacement rule, what most vendors miss.
What the 5-year cycle is.
Most commercial-rated photoelectric and ionization smoke detectors carry a manufacturer-listed cleaning interval at five years (some platforms specify three or seven). The interval intersects with the §14 sensitivity-testing schedule — at the cleaning event, the detector is bench-tested for sensitivity, cleaned per manufacturer procedure, and reinstalled (or replaced if it has drifted beyond range).
How it is performed.
The audit-grade approach: detectors removed in batches, bench-tested using a calibrated sensitivity instrument, cleaned in an environmentally controlled work area, re-tested, and reinstalled with the original or replacement address. Field-only methods (compressed-air canister at the ceiling) are inadequate for the cleaning specification on most listed devices; they may dislodge dust without removing it.
Common misses on the 5-year cycle.
Vendors that perform an annual visual inspection but skip the 5-year cleaning. Vendors that perform ‘cleaning’ as a compressed-air shot at the ceiling — not adequate. Buildings where the original install date is unknown, so the 5-year mark is uncalculatable. Tyrian establishes the install-date baseline as part of the panel-handover intake.
5-year cycle FAQs.
Is the 5-year cleaning required or recommended?
NFPA 72 §14 requires sensitivity testing per the manufacturer’s listing; manufacturers commonly specify cleaning at the five-year mark. The combined practice is functionally required.
What if I do not know the original install date?
Tyrian establishes the baseline through detector date-code (most listed detectors carry a date stamp) and the panel programming records where available.
Does the 5-year cleaning extend the 10-year replacement rule?
No. The §17.7.1.7 ten-year replacement rule applies independently.
Does Tyrian do this as part of the standard ITM?
The 5-year cycle is a separate scope from the standard annual ITM. It is scheduled into the ITM plan at the appropriate interval.

